Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36
Operation
28

Battery Maintenance

Please only use the original battery charger for charging the battery .
1. Battery capacity check
Press the battery check button on the backside
of the battery to check the current
battery capacity .
4 sections:
3 sections:
2 sections:
1 section:
0 section:
2. Notes:
• Turn off the flash before taking out the battery .
• The battery will achieve optimal performance only after two or three complete
charge and discharge cycles .
• If the flash is used outdoor, the usage time might be shorter than normal .
• The proper working temperature of the battery is +15°C and +25°C . Please note
that the environmental temperature might effect the battery run time . If the
temperature is lower than 0°C, the battery will be limited even with full power .
• If the flash is indicated that the battery power is low, please change the battery
and recharge it . If you keep working, the battery might be damaged .
• If the flash will not be used for a long time, please fully charge the battery
before storing it in a cool and dry place . Please note that the battery needs to be
recharged at least every 3 months .
• After long term or heavy use please let the battery cool down for about
10 minutes before storing .
100–75%
75–50%
50–25%
25–5%
less than 5%
ENGLISH

Publicité

Table des Matières
loading

Table des Matières