Care And Maintenance - DesQ 70245 Instructions D'opération

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

7. It is recommended to switch off the machine for 30 minutes, after it has been operating for a period of
approximately 2 hours.
8. Do not laminate dirty or damaged pouches.
9. Trim excess pouch material from around your item after laminating and cooling.
10. Do not laminate heat-sensitive documents (i.e., tickets, ultrasounds, etc.).
11. Use a dry-erase marker for writing on laminated pouches.
12. Use DESQ® brand pouches for best results. Select correct pouch size, and thickness, for laminated item.

CARE AND MAINTENANCE

1. If the pouch is rolled into the laminator or break down, send your machine to your service point for
repairing. DO NOT open the housing of the machine.
2. Unplug the machine while it is being wiped. Clean the machine with a slightly moist, soft cloth. Do not
use a wet cloth or any caustic or abrasive cleaning agents while doing so.
IMPORTANT SAFEGUARD
1. The unit is intended for indoor use only.
2. Do not drop the machine or put any object on top of it to avoid the housing to break. If it happens,
unplug the laminator.
3. The pouch laminator must be connected to a supply voltage corresponding to the electrical rating of the
machine asindicated.
4. Children have to be attended by adults while using the machine; to protect the children from being burnt
of shocked.
5. If the laminator smells burning, unplug the machine immediately and contact the service representative.
6. Unplug the laminator before it is moved, or when it is not in use for an extended period of time. When
using the laminator for an extended time, turn off the machine for an hour for every other eight hours.
7. Do not place the laminator near a heat generating object like furnaces or radiators.
8. The machine and the power cord should be away from water to avoid electrical shock.
9. Place unit on a secure, stable area to prevent the machine falling and possibly causing personal injury
and damage to the unit.
10. If the supply cord is damaged, it must be replaced by the manufacturer or its Service Agent or similarly
qualified person in order to avoid a hazard.
11. Before laminating valuable items, do a test run with an item similar in size and thickness.
Manual NW 70245.indd 5
4-11-2010 14:45:56

Publicité

Table des Matières
loading

Table des Matières