Care And Maintenance - DesQ 70250 Instructions D'opération

10. Trim excess pouch material from around your item after laminating and cooling.
11. Do not laminate heat-sensitive documents (i.e., tickets, ultrasounds, etc.).
12. Use a dry-erase marker for writing on laminated pouches.
13. Use DESQ® brand pouches for best results. Select correct pouch size, and thickness, for
laminated item.

CARE AND MAINTENANCE

1. If the pouch is rolled into the laminator or break down, send your machine to your service-
point for repairing. DO NOT open the housing of the machine.
2. Unplug the machine while it is being wiped. Clean the machine with a slighly moist, soft
cloth. Do not use a wet cloth or any caustic or abrasive cleaning agents while doing so.
IMPORTANT SAFEGUARD
1. The unit is intended for indoor use only.
2. Do not drop the machine or put any object on top of it to avoid the housing to break. If it
happens, unplug the laminator.
3. The pouch laminator must be connected to a supply voltage corresponding to the electrical
rating of the machine asindicated.
4. Children have to be attended by adults while using the machine; to protect the children from
being burnt of shocked.
5. If the laminator smells burning, unplug the machine immediately and contact the service
representative.
6. Unplug the laminator before it is moved, or when it is not in use for an extended period of
time. When using the lamintor for an extended time, turn off the machine for an hour for
every other eight hours.
7. Do not place the laminator near a heat generating object like furnaces or radiators.
8. The machine and the power cord should be away from water to avoid electrical shock.
9. Place unit on a secure, stable area to prevent the machine falling and possibly causing per-
sonal injury and damage to the unit.
10. If the supply cord is damaged, it must be replaced by the manufacturer or its Service Agent
or similarly qualified person in order to avoid a hazard.
11. Before laminating valuable items, do a test run with an item similar in size and thickness.
SOLVING A JAM
Turn the power of the laminator by turning the switch (4) to ABS. Let the machine cool down
briefly (for hot laminating). Hold the switch firmly on ABS mode with one hand and pull out the
film completely from the machine's insert or outlet opening with the other hand.
Manual NW 70250.indd 5 14-12-2010 16:58:27