Electromagnetic Compatibility Information - Lanaform ABPM-100 Mode D'emploi

ELECTROMAGNETIC COMPATIBILITY INFORMATION

Guidance and manufacture's declaration - electromagnetic emissions
ABPM-100 is intended for use in the electromagnetic environment specified below.
The customer or the user of ABPM-100 should assure that it is used in such an environment.
Emissions test Compliance
RF emissions Group 1
CISPR 11
RF emissions Class B
CISPR 11
Harmonic emissions Not applicable
IEC 61000-3-2
Voltage fluctuations/ Not applicable
flicker emissions
Guidance and manufacturer's declaration - electromagnetic immunity
ABPM-100 is intended for use in the electromagnetic environment specified below.
The customer or the user of ABPM-100 should assure that it is used in such an environment.
Immunity test IEC 60601test level Compliance level
Electrostatic discharge (ESD) ± 6 kV contact
IEC 61000-4-2 ± 8 kV air
Power frequency 3 A/m
(50/60 Hz)
Magnetic field
IEC 61000-4-8
Electromagnetic environment - guidance
ABPM-100 uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
ABPM-100 is suitable for use in all establishments other than domestic
and those directly connected to the public low-voltage power supply
network that supplies buildings used for domestic purposes.
Electromagnetic environment - guidance
± 6 kV contact Floors should be wood, concrete or ceramic tile. If
± 8 kV air floors are covered with synthetic material, the
relative humidity should be at least 30 %.
3 A/m Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment.
ABPM-100 EN Instruction manual
EN
FR NL DE SL SV
11
/ 74