Ecor Pro LD800 Manuel D'instructions page 6

POSITIONING YOUR LD800
WARNING
Before using the appliance it should be left in an upright position for at least 2 hours.
Your unit can be installed in any area with a relative humidity that is too high;
such as a basement, play area, shed, archive room, swimming pool, boat, etc.
The unit will begin to protect from the harmful effects of excess moisture as soon it is
installed an plugged in. The unit can stand on the floor or hung on a wall.
When positioning your unit, ensure that it is placed level.
Best results are obtained when windows and doors are closed, thus preventing the pos-
sible influx of fresh, too humid, air.
This appliance must be grounded and should only be
connected to a grounded 110V ~/ 60 Hz main supply.
The installation must be in accordance with the regula-
tions of the country where the unit is used.
The unit is designated for indoor operation only.
Connecting a controller (optional)
Optional controller to give on-off controls and regulate user-set environment.
The controller is used to sense the conditions in the home. When the humidity gets be-
yond the user defined level. The LD8
More complex controllers can be fitted to react to temperature and CO
Transportation tie should be removed only after
installation is complete. Do not forget!
6
oo
will automatically start working.
Low voltage terminal block. Used to connect optional controller.
Remove the cover, two
screws. Connect the
controller as indicated.
X
X
A B C
.
2
A For connecting to
central air or heating
controller
B To control
dehumidification
C To control just the fan
only and circulate air,
but not dry the air