Black & Decker Price Pfister 34 Serie Mode D'emploi page 6

20
20D
20 DIVERTER REMOVAL
If the side spray fails to work properly the diverter mechanism may be clogged with debris
or may need replacing. To check and/or replace Diverter (20A), shut off water supply
and relieve pressure before working on your faucet (see step 2). Remove handle
(see step 17) and Dome Cap (20B) and carefully lift up the Spout Assembly (20C). The
Diverter Mechanism (20A) is located on the backside of Inner Faucet Body (20D) Carefully
remove the Diverter Mechanism (20A) and check for debris. Clean or replace the Diverter
Mechanism (20A). Reassemble faucet by reversing steps.
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased your faucet.
2. When replacement parts are not available, please write or call Price Pfister
Consumer Service.
3. Always turn off water and relieve pressure before working on your faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp cloth to clean and shine.
Use of polish, detergents, abrasive cleaners, organic solvents or acid may cause
damage. Use of other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar substance are not acceptable for
public areas or Commercial use. Installation of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call 1–800–PFAUCET
(1–800–732–8238) or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
ENGLISH
20B
20C
20A
6