Optical Digital Output; Coaxial Digital Output - Arcam FMJ CD37 Manuel

Power inlet
Connect the correct
mains cable here.
�����������
��������������������
Voltage select
Ensure the voltage selected matches
the local power supply.
12V trigger input
This socket allows the CD37 to be switched
in and out of stand-by mode by an amplifier
(or another item of AV equipment) with a
12V trig out
��������
��
������
�������
������
��
����������
��������
Remote in
This allows remote-control signals
to be received by the CD37 if
the remote sensor is covered
(or otherwise not 'visible' to the
remote-control).
See page 4 for more information.
Use this socket if you are using a separate digital
to analogue converter (DAC) or digital recorder.
function.
�����������������
�������
����

optical digital output

Use this socket if you are using a
separate DAC or digital recorder with
an optical connection. Connect using a
suitable optical cable.

coaxial digital output

Connect to the DAC or recorder's digital input
using a suitable 75 Ω screened cable.
CAUTION: Never connect the digital output
socket to a conventional audio input.
e-5
�������������������
�
�
� �
analogue audio outputs
Connect these to your amplifier's CD (or other
line-level) input using suitable high quality
interconnect cables. Ensure that the left and
right audio outputs from the CD player are
connected to the same left and right inputs on
your amplifier.
The second set of sockets can be used to connect
to a second amplifier set up for multi-room use.