Pairing A Bluetooth Device - ION BLOCK PARTY Guide D'utilisation Rapide

Power Cable Input (IEC): Insert the included power cable here to power the unit.
8.
Power ON/OFF Switch: Turns BLOCK PARTY on or off.
9.
TROUBLESHOOTING
If the sound is distorted: Try lowering the volume control of your sound source or musical instrument. Also, try to reduce the
overall volume of BLOCK PARTY.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass level. This will allow
you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably feedback. Point the microphone away
from the speaker.
If you can't hear the microphone over the music volume: Turn down the music volume from your source.

PAIRING A BLUETOOTH DEVICE

1.
Turn on your Bluetooth device.
2. Power on BLOCK PARTY and it will automatically go into pairing mode to search for Bluetooth devices. You will know
you are in pairing mode when the LED is blank.
If your Bluetooth device is not able to pair to the amp, press the disconnect button on the amp to break previous
3.
Bluetooth connections and reset the Bluetooth module.
Navigate to your Bluetooth device‟s setup screen, find "ION Audio Speaker" and connect.
4.
Note: If your Bluetooth device prompts for a pairing code, enter „0000‟.
BLOCK PARTY LED will light up solid when it is 'paired'.
Note: Users should consider updating their OS if experiencing trouble with pairing or playing music.
5.
To disconnect pairing, press the „Disconnect‟ button on BLOCK PARTY.
To connect to another Bluetooth device, repeat steps 3-4.
6.
7.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0.
9
8
4