ION Party Starter Guide D'utilisation Rapide page 2

Box Contents: Party Starter, USB Charging Cable,
Quickstart Guide.
Charging Party Starter: Use the included mini-USB cable to
connect Party Starter to (A) a USB power adapter connected
to a power outlet or (B) your computer (powered on) for 3
hours.
Controls: (1) Volume/Power;
(2) Power Light; (3) Bluetooth
Pairing Light; (4) Party Light
Switch; (5) Battery Light; (6)
mini-USB Charging Port.
Getting Started: (1) Turn up the Volume dial to power Party
Starter on. (2) Open Bluetooth settings on your music device
(smartphone, tablet, etc.). (3) Connect to ION Party Starter.
(4) Play music and adjust Party Starter's Volume dial. For
best results, use it in a dark room! For the complete user
guide, visit ionaudio.com/partystarter.
Box Contents: Party Starter, USB Charging Cable,
Quickstart Guide.
Charging Party Starter: Use the included mini-USB cable to
connect Party Starter to (A) a USB power adapter connected
to a power outlet or (B) your computer (powered on) for 3
hours.
Controls: (1) Volume/Power;
(2) Power Light; (3) Bluetooth
Pairing Light; (4) Party Light
Switch; (5) Battery Light; (6)
mini-USB Charging Port.
Getting Started: (1) Turn up the Volume dial to power Party
Starter on. (2) Open Bluetooth settings on your music device
(smartphone, tablet, etc.). (3) Connect to ION Party Starter.
(4) Play music and adjust Party Starter's Volume dial. For
best results, use it in a dark room! For the complete user
guide, visit ionaudio.com/partystarter.
Box Contents: Party Starter, USB Charging Cable,
Quickstart Guide.
Charging Party Starter: Use the included mini-USB cable to
connect Party Starter to (A) a USB power adapter connected
to a power outlet or (B) your computer (powered on) for 3
hours.
Controls: (1) Volume/Power;
(2) Power Light; (3) Bluetooth
Pairing Light; (4) Party Light
Switch; (5) Battery Light; (6)
mini-USB Charging Port.
Getting Started: (1) Turn up the Volume dial to power Party
Starter on. (2) Open Bluetooth settings on your music device
(smartphone, tablet, etc.). (3) Connect to ION Party Starter.
(4) Play music and adjust Party Starter's Volume dial. For
best results, use it in a dark room! For the complete user
guide, visit ionaudio.com/partystarter.
Notice Concerning FCC Regulations: You are cautioned that changes or modifications not
expressly approved by the part responsible for compliance could void the user's authority to
operate the equipment. This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures: (a) reorient or relocate the
receiving antenna; (b) move this unit; (c) increase the separation between the equipment and
receiver; (d) connect the equipment into an outlet on a circuit different from that to which the
receiver is connected; (e) be sure that all cables are properly shielded, using a choke or ferrite
where appropriate; (f) consult the dealer or an experienced radio/television technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
ESD / EFT Warning: This unit may contain a microcomputer for signal
processing and control functions. In very rare situations, severe interference,
noise from an external source, or static electricity may cause it to lock up. In the
unlikely event that this should happen, turn off the unit, wait at least five
seconds, and then turn it back on again.
In an environment with radio frequency interference, the unit may malfunction and resume
normal operation after removal of the interference. For best audio quality, avoid using this
device in a high RF-radiated environment. This unit does not exceed the Class B limits for
radio noise emission from digital apparatus set out in the radio interference regulations of the
Canadian Department of Communications.
or
®
5 6
4
or
®
5 6
4
or
®
5 6
4
2
3
1
2
3
1
2
3
1