Technical Details; Packing And Transport - Benassi FT 530 E Livret D'utilisation Et D'entretien

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

S.p.A.

FOR THE ENGINE FEATURES SEE THE ENGINE INSTRUCTION BOOKLET DELIVERED WITH THE MACHINE.

•

Acoustic pressure to the operator: LpA = 86 dB (A) without front guard.

•

Noise Level recorded: Lwa 97dB (A)

•

Noise level allowed: Lwa 100 dB (A)

•

Vibration to handles with weighting ISO.5349 value 8,19m/sec².

•

Fuel : unleaded petrol

•

Recoil Starter.

•

Dry Air filter .

•

Oil in the gearbox : AGIP Diesel SIGMA SAE 30 0,6 Lts.

•

Speed: 3 km/hour

•

Safety electric stop on the handle-bar.

The identification details of the machine ( Code Number, Engine Number, Weight, Power), are listed in a little Number Plate, as shown in Pict. 2,

ref. A

◊

WIDTH: 118 cm

• The MACHINE is delivered packed IN CARTON BOX..

• After having removed the rotary mower from the box, fix the handle-bar (Pict. n°3)

• Mount the side conveyer on the deck, as shown in Pict.4 , using the four bolts M8 included.

• The machine is delivered with oil in the gear-box.

• ATTENTION: THE NEW MACHINES ARE DELIVERED WITHOUT OIL IN THE ENGINE. Fill with Oil SAE30 the engine,

through the inlet Pict.1 Pos. 5, and check the correct level (using the liner in the oil cap).

• After mounting the handle-bar, you should adjust the control-cables.

• The motor- stop and driving levers must be adjusted with the running engine (as mentioned in the next chapter)

• It is important to verify that the safety motor-stop lever, Pict.5 Pos. C, is properly working : when you release it, it should

immediately stop the engine, and the blade (within 7 seconds). The engine is working only when you press the lever. You can

adjust it, if necessary, through the screw Pos. D , Pict. 5.

• You can adjust the Power drive lever, Pict. 5, Pos..A, considering that the correct adjustment is when the machine starts to move,

and the hand lever is around 30° from the vertical position. If necessary, you can adjust it , through screw Pos. F.

• The adjustment of the mowing height , through lever B, in Pict. 5, should be done with engine OFF. This lever is blocking the

whole chassis in three different positions. You can adjust this cable, through the screw Pos. E in Pict. 5.

• The cable of the accelerator doesn't need any adjustment.

IMPORTANT: THE PACKED MACHINE IS SUPPLIED WITH THE MOTOR WITHOUT OIL OR PETROL.