Installing The Handle - Zephyr PRB24C01BPG Guide D'utilisation, D'entretien Et D'installation

Installation Instructions

Installing the Handle

If an optional contemporary or pro handle is desired, refer below for the handle
dimensions and part number.
1. Confirm if the overlay panel has already been
installed onto the unit. If not, refer to Overlay
Panel Installation to mount the overlay panel
onto the unit.
2. Push aside the door gasket. Under the gasket
you will see two designated holes for handle
installation. Mark handle hole locations on
the overlay panel.
Remove overlay panel from door. Using 3/16"
3.
drill bit, create holes for handle screws.
4. Re-install overlay panel on the door.
5. Install the handle tightly as shown with
two 1-1/2" machine screws.
NOTE: If using a custom handle, install the handle in the position of your
choosing with counter sunk screw holes prior to installing the overlay panel to
door.
16