Zephyr PRB24C01BPG Guide D'utilisation, D'entretien Et D'installation page 15

Installation Instructions
Overlay Panel Installation
To install the overlay panel onto the door, please follow the instructions below. Refer to
the dimensions page to ensure proper measurements prior to installation.
1. Open the door.
2. Temporarily remove the door gasket to see the 10 holes for the overlay panel. There
are 2 holes on the top and bottom sides of the door with either 3 or 5 holes on the
left and right side depending on where the handle is located. The handle side will
have 5 holes.
3. Open the hardware package containing 10 self-tapping screws (ST4*30 size) for the
overlay panel.
4. Clamp the overlay panel with the door firmly with bar clamps and screw the self-
tapping screws into the overlay panel. Perform this step per screw until the overlay
panel is completely secured.
5. Reattach the door gasket and close the door.
NOTE: If handles will be installed, thread 2 pre-installed screws onto the overlay panel
and refer to Installing the Handle instructions. If they will not be installed, remove the
screws from the door.
15