Fuselage To Mast Assembly; Important; Stabilizer Assembly; Front Wing Assembly - North FOIL Manuel De L'utilisateur

3.2. FUSELAGE TO MAST ASSEMBLY

1. Ensure all surfaces are free from dirt or sand prior to assembly. This is particularly
important when assembling the Fuselage onto the Mast using the GeoLock connection.
2. Locate the marine grease provided in the Tool Kit.
3. Apply a small amount of the grease to the threads of the screws provided in Screw Pack B
(Note: the two screws supplied in Fuselage Screw Pack B will come preassembled with a
plastic washer on the bottom and stainless steel washer on top).
Position the Fuselage onto the bottom of the Mast whilst ensuring the correct orientation
4.
is maintained.
IMPORTANT: Due to the tapered design of the Geolock Connection between the Fuselage
5.
and the Mast, it is very important that you carefully tighten each of the two screws evenly
(matching turns of each screw at a time). If you tighten one screw significantly more than
the other, the Fuselage could locate unevenly and damage the Geolock Connection.
6. Using the technique described in step 5, tighten the screws using the Torx T40 tool
provided in the Tool Kit until the Geolock Connection is level and even with the Fuselage
top surface and the screws are firmly tight.

3.3. STABILIZER ASSEMBLY

1. Ensure all surfaces are free from dirt or sand prior to assembly.
2. Locate the marine grease provided in the Tool Kit.
Apply a small amount of the grease onto the threads and undersides of the heads on the
3.
two screws supplied in Stabilizer Screw Pack C.
Attach the Stabilizer to the rear of the Fuselage using the two greased screws.
4.
5. Tighten the screws using the Torx T40 tool provided in the Tool Kit until the Stabilizer is
fully secured and the screws are tight.

3.4. FRONT WING ASSEMBLY

1. Ensure all surfaces are free from dirt or sand prior to assembly.
Locate the marine grease provided in the Tool Kit.
2.
3. Apply a small amount of the grease onto the threads and undersides of the heads on the
three screws supplied for your wing of choice in either Wing Screw Pack D, E, F, or G.
4. Attach the Front Wing to the front of the Fuselage using the three greased screws.
5. Tighten each screw equally by hand securing the Front Wing. Then use the Torx T40 tool
provided in the Tool Kit to fully secure the Front Wing and ensure screws are firmly tight.
U S E R M A N U A L F O I L
1 5