Maintenance And Care; Maintenance Intervals - Kärcher CV 66/2 Mode D'emploi

Vacuuming
Large waste such as cardboard cups,
cardboard plates, strings and similar ob-
jects must be picked up prior to vacuum-
ing.
Insert the plug into the socket.
Set the appliance switch to "ON".
Ride along the surface to be cleaned
with a suitable, even speed.
Heavy soiling must be worked on several
times or slower.
Warning!
Risk of damage to the floor covering. Do not
operate the appliance on the spot.
Due to the one-sided arrangement of the
brushes, the right side of the appliance
can clean all the way to the edge.
If the display for a full filter bag is illumi-
nated, switch the appliance off and re-
place the filter bag.

Maintenance and care

Warning
Risk of injury. Pull the plug from the mains
before carrying out any tasks on the appli-
ance.

Maintenance intervals

Daily
If needed, shake the contents of the filter
bag downward.
Check the mains connection cable for
damages. Replace the defective mains
cable.
Clean below the appliance.
Remove fibres, hair and strings from the
brush rollers.
Check and clean seals, replace dam-
aged seals.
Weekly
Clean brushes and check for wear and
tear.
The brushes are considered worn, if the
bristles have the same length as the yel-
low indicator bristles.
10
English
Monthly
Clean the motor protection filter on the
bottom of the filter chamber and check
for damage.
Half-yearly
Remove the wheels, clean the axles and
apply a thin coat of silicone grease.
Replacing the filter bag
Open lid of filter chamber.
Pull the filter bag off the connection hub
and remove them from the appliance.
Insert new filter bag (see "Replacing filter
bag").
Replacing the brush rollers
Disconnect the main plug from the sock-
et.
Tilt the appliance backward and store it
on the pushing handle.
1 Locking plate
2 Bearing block
3 Brush roller
4 Driver pin