S&P CAIB Serie Manuel D'instructions page 25

Main screen:
Date:yy:mm:dd
Setpoint
temperature
(Sp)
A
DJUSTING THE SETPOINT FOR TEMPERATURE REGULATION
From the main screen:
Reg. new air intake
06:11:09 16:09
system: active
Sp: 23.0 Act:23.4°Cq
u current/Setpoint p
Input/Output
Time setting
Setting
1/ If access is authorized, the following screen appears
- press OK
- then enter changes using keys
p , u , q and t
- confirm by pressing OK
- To exit configuration mode: press keys t
2/ If access is not authorized, the following screen appears
- now enter 3333
using keys p , u , q and t
- confirm by pressing OK
- wait a few seconds until the screen showing the blow temperature appears
- then enter changes using keys
p , u , q and t
- confirm by pressing OK
- To exit configuration mode: press keys t
Programming
Reg. new air intake
06:11:09 16:09
system: active
Sp: 23.0 Act: 23.4°Cq
- press keys q , u then u
- then press OK
Ext Temp: NaN °C
Output temp.
Act: 18.3°C
SetP: 23.0°C
Output temp.
SetP:
23.0°C
q
, t then p
Log on
Password: ____
Actual level:none
Output temp.
SetP: 23.0°C
q
, t then p
Time
Temperature measured
by sensor
(Act)
Output temp.
SetP: 23.0°C
Setp->
u
Output temp.
SetP: 15.0°C
Log on
Password: 3333
Actual level:active
Output temp.
SetP: 15.0°C
q
q
q