Technical Data; Care And Cleaning; Declaration Of Conformity (Doc) - Eurochron Jumbo Mode D'emploi

To activate / deactivate the alarm
• Press the button ALARM (B3) in order to activate or deactivate the alarm function.
• A bell symbol appears in the display, if the alarm function is activated.
• To cancel the alarm tone and to activate the snooze function during the alarm, press the
SNOOZE (B2) button.
• While the alarm tone is interrupted, the symbol "Zz" flashes in the display. The alarm tone will
resume after 5 minutes. This procedure can be repeated up to seven times.
• To turn off the alarm tone entirely when the alarm is activated, press any button except
SNOOZE (B2). This will turn off the alarm tone for 24 hours and it will be started again on
the next day.
The alarm tone switches off automatically after two minutes if it has not been turned
off before then.
Troubleshooting
The clock does not synchronise or only has temporary reception:
• The distance to the DCF transmitter is too long or restricted by geographical conditions.
• Relocate the product; switch off interfering devices such as TV sets, computers or microwave
ovens.
• Avoid a location in the vicinity of large metal surfaces, which may shield the radio signals.
Windows with a vapour deposited metal layer can also influence the signal reception.
• Place the clock near a window for synchronisation, and align the front or back side in the
direction of Frankfurt (Germany).
• Leave the clock switched on overnight to avoid atmospheric interference.
The displayed temperature value is not correct:
• The clock or the outdoor sensor is exposed to direct sunlight.
• The clock or the outdoor sensor is located too close to a heat source (heater, electronic
device, etc.)
The device does not react when buttons are pressed, the display shows strange
symbols, or the display is blank:
• Press the RESET (B7) button with a pointed object (e.g. a ball pen tip). By doing so, the built-
in micro processor will be reset and restarted.
The display of the base station has spots:
• The display has been subjected to stress. The spots will disappear by themselves. This may
take a while, depending on the ambient temperature.

Care and cleaning

• Remove the batteries from the product before cleaning.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as
they can cause damage to the housing and malfunctioning.
• Clean the outside of the product with a soft, dry, fiber-free cloth.
• Do not immerse the product in water.

Declaration of Conformity (DOC)

Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau hereby declares that this
product conforms to the 2014/53/EU directive.
Click on the following link to read the full text of the EU declaration of conformity:
www.conrad.com/downloads
Select a language by clicking on a flag symbol and enter the product order number
in the search box. You can then download the EU declaration of conformity in PDF
format.
Disposal
a) Product
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
Remove any inserted (rechargeable) batteries and dispose of them separately from
the product.
b) (Rechargeable) batteries
As the end user, you are required by law (Battery Ordinance) to return all used
(rechargeable) batteries; disposal of them in the household waste is prohibited!
Contaminated (rechargeable) batteries are labelled with this symbol to indicate that
disposal in the domestic waste is forbidden. The designations for the heavy metals
involved are: Cd = Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable)
batteries, e.g. below the trash icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our
stores or wherever (rechargeable) batteries are sold.
You thus fulfil your statutory obligations and contribute to the protection of the environment.

Technical data

Batteries ..................................................... 4 x 1.5 V Mignon cell (AA) (base station)
Battery life ................................................... approx. 2 years
Radio frequency ......................................... 433 MHz
Transmission range .................................... up to 100 m (free field, direct visual contact)
Time protocol .............................................. DCF
Alarm tone duration/repeated alarm ........... 2 min/ 5 min
Time format ............................................... 12/24 h
Measuring range of thermometer ............... indoors 0 to +50 °C / outdoors -20 to +50 °C
Dimensions (W x H x D) ............................. 368 x 229 x 30 mm (base station)
Weight ........................................................ 900 g (base station)
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE.
2 x 1.5 V Micro cell (AAA) (outdoor sensor)
101 x 62 x 23 mm (outdoor sensor)
65 g (outdoor sensor)
*1600381_V1_0118_02_mxs_m_en