Kalorik FT 44247 Mode D'emploi page 20

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Remove the basket handle from the basket.
Remove the control panel assembly from the oil reservoir. Carefully
clean the control panel assembly and immersion heater with a
damp cloth.
Pull the oil filter cover from the oil reservoir and then remove the oil
reservoir from the housing.
Open the lid filter cover and remove both black and white filters.
Clean the appliance housing with a damp cloth.
Wash the lid, basket, basket handle, oil reservoir and oil filter cover
with hot soapy water or in a dishwasher. Rinse and dry carefully.
Dry all parts thoroughly after cleaning and before using the
appliance again.
NOTE:
If the oil container needs to be cleaned, ensure it is empty
before attempting to clean (see Emptying the oil container).
Wash with hot soapy water or in a dishwasher. Rinse and dry
carefully.
Clean the filters every 3 months or after every 12 uses with hot
soapy water. Do not clean in a dishwasher.
Dry all parts and surfaces thoroughly before use. Make sure that
all parts and surfaces are completely dry before connecting the
appliance to a wall outlet. Even a small amount of water can
cause severe splattering of hot oil.
CLEANING THE FILTRATION SYSTEM:
The oil filter cover and filtration system should be cleaned regularly for
optimal filtration performance.
Twist and pull the filter cover to remove it from the bottom of the oil
reservoir and clean it thoroughly in warm, soapy water to remove any
hardened grease, crumbs or other food debris.
www.KALORIK.com
20
FT 44247 - 200605

Publicité

Table des Matières
loading

Table des Matières