Kalorik FT 44247 Mode D'emploi page 17

• Ensure the oil container is assembled, empty and in place inside the
appliance.
• Once the oil has cooled down to room temperature, turn the oil
filtration control knob to the FILTER OIL position. The oil will start
dripping inside the oil container. The oil filter cover will keep food
residues from being transferred to the oil container.
• When all oil has been filtered:
Turn the oil filtration control knob to the LOCK position if the
‒
container will remain inside the appliance.
Turn the oil filtration control knob to UNLOCK position if the
‒
container is to be removed from the appliance.
CHANGE OIL LIGHT: This deep fryer comes with an indicator light as a
reminder to change the oil. After every 10 uses, the change oil indicator
lights notifying the user to change the oil in the tank. Once the oil has
been changed, press the RESET button on the main control panel for 3
seconds to indicate that the oil has been changed and reset the cycle.
NOTE:
Wait for the 'Filter Oil' light to be turned on before filtering.
‒
Otherwise, wait 3 to 4 hours until the oil has cooled down
completely before draining or filtering.
Extreme caution must be used when moving the appliance
‒
while the oil reservoir and oil container are not both empty.
When removing the oil container from the appliance, handle
‒
with care. Keep the oil container flat and hold it with both
hands.
Emptying the oil container
Filtered oil can be stored in a suitable container (see Storing oil) or re-
used for frying a new batch of food (see Cooking with oil).
• Unscrew the cap on top of the oil container.
• Slowly pour the oil container content into a suitable container or the
oil reservoir, if required.
NOTE:
Ensure the oil filtration control knob is on UNLOCK position before
‒
pouring oil into the oil reservoir.
www.KALORIK.com
17
FT 44247 - 200605