Haverland TAC-0918 Mode D'emploi page 67

TROUBLESHOOTING
PROBLEM
• there is no current
The air conditioner
does not come on
• it is not plugged into the mains
• the interna! safety device has
tripped
The air conditioner • here are bends in the air ex­
works for a short time haust hose
only
• something is preventing the
air from being discharged
The air conditioner • windows, doors and/or cur­
works, but does not tains open
cool the room
• there are heat sources in the
room (oven, hairdryer, etc)
• the air exhaust hose is deta­
ched from the appliance
• the technical specification of
the appliance is not adequa­
te for the room in which it is
located.
During operation, • airfilter clogged
there is an unplea­
sant smell in the
room
• the interna! compressor safety
The air conditioner
does not operate for device prevents the applian­
about three minutes ce from being restarted until
after restarti ng it three minutes have elapsed
since it was las! turned off.
The following message
• the appliance has a self dia
appears on the display:
gnosis system to identify a
U:/ P F / FI:.
number of malfunctions.
CAUSE
• wait
• plug into the mains
• wait 30 minutes, if !he problem
persists, contact your service cen­
ter.
• position the air exhaust hose
correctly, keeping it as short
and free of curves as possible
to avoid bottlenecks
• check and remove any obsta­
eles obstructing air discharge
• close doors, windows and
curtains, bearing in mind the
"tips for correct use" given
above
• eliminate the heat sources
• fit the air exhaust hose in the
housing at the back of the
appliance (fig. 1).
• Clean the filler as discribed
Above.
• wait. This delay is part of nor­
mal operation.
• See the SELF-DIAGNOSIS
Chapter
69
SOLUTION