Power Up & Installation Verification Checklist - Leviton R08DD-L08 Guide D'installation

Power-Up & Installation Verification Checklist
Prior to the application of power to your relay cabinet, all of the following steps
must have been successfully executed.
• Inspect each relay load wiring for incomplete termination
• Inspect each relay's load wiring for terminals not completely tightened
• With each relay in the "OFF" position, check for voltage between the Line & Load
terminals; there should be none.
• Inspect all low voltage wiring and ensure that it is complete.
• Inspect control power wiring, ensure that it is complete.
• Confirm that any unused supply wires on the control power transformer have been
suitably capped.
• Confirm that all connected load wiring between the relay panel and it's load has
been completed.
• Confirm that wiring between the cabinet and all low voltage devices has been
completed.
• Apply power to the cabinet.
• Confirm that the cabinet boots properly and returns to the status "normal" screen.
• Set the Time & Date from the menu.
• Update system software with the latest available software from the website, if
appropriate.
• Proceed to panel programming.
14