Assembly and Operating Instructions
SWIMMING POOL PUMP FOR FILTER SYSTEM
NOTE: This pump is intended exclusively for use with a filter system. Please read the operating instructions for
the filter and pump together to ensure an appropriate use of the complete system.
GENERAL
This manual intends to ensure that the pump is properly installed and to achieve an optimal performance.
Please read the instructions carefully. The pump is designed to be operated together with a swimming
pool filter system and may only be operated with clean water with a temperature of 5°C to 35°C.
The pump is made of quality materials that are subject to strict hydraulic and electrical controls and are carefully
checked. Please follow these instructions to ensure a proper assembly. We do not accept liability for possible
damage caused by failure to observe these operating instructions.
IMPORTANT SAFETY INSTRUCTIONS
Always observe the following basic safety precautions when installing and using the pump.
CAUTION: THE PUMP MUST NOT BE USED WHEN THERE ARE PEOPLE IN THE WATER.
1. READ THE INSTRUCTIONS BELOW AND READ THE INSTRUCTIONS IN THE FILTER MANUAL
2. WARNING: The device is not intended for use by persons (including children) with limited physical, sensory
or mental capabilities or lack of experience and knowledge, unless they are supervised by a responsible
person when using the device or they have been instructed with regard to the relevant safety precautions.
Children should be supervised to ensure that they do not play with the device.
3. OPERATE THE PUMP ONLY VIA AN ISOLATED GROUND RECEPTACLE WITH AN EARTH-LEAKAGE
CIRCUIT BREAKER (RATED RESIDUAL CURRENT MAXIMUM 30MA).
4. CAUTION: Do not switch on the pump until the filter is properly connected and the water supply is available.
5. WARNING: To reduce the risk of electric shock, damaged cables should be replaced immediately by a
qualified electrician.
6. WARNING: To reduce the risk of electric shock, extension cords should not be used to connect the device
to the mains supply. Install a power outlet..
7. WARNING: Protect the pump and other electrical parts from possible splash water. Danger to life due to
electric shock. We recommend placing the pump on a concrete slab and never directly on the lawn.
8. DO NOT LET THE PUMP RUN DRY! MAKE SURE THAT THE PUMP IS CONNECTED TO THE FILTER
SYSTEM AND TO THE POOL IN SUCH A WAY THAT THE WATER LEVEL IS HIGHER THAN THE
WATER OUTLET.
9. KEEP THESE INSTRUCTIONS IN A SUITABLE PLACE.
10. CAUTION: Do not lay cables in the ground. Lay the cable so that possible damage caused by lawnmowers,
hedge trimmers and other devices is minimized. We do not accept liability for any damage to cables.
7