BOND MANUFACTURING HYFP30205-96 Guide D'utilisation page 9

ASSEMBLY
*Please keep the owner's manual for future reference
*If you have opened the carton and removed all packages, please disregard the STEP 1
STEP 1
(1) Open the carton and turn it upside
down, make sure the 4 pieces of
the carton being open up as below.
(2) Lift off the carton carefully and be
wary of the accessories inside
falling away. Take away the boxes
containing lava rocks.
(3) Take all the packing materials
away except for the polyfoam
rounding the firebowl.
See Figure STEP 1.
STEP 2
(1) Turn the firebowl heads up on a flat
ground.
(2) Cut off the binding tape on the
polyfoam and remove all the
polyfoam rounding the top of the
firebowl.
(3) Cut off the tie fastened the regulator
at the metal stand and set it free for
installation to propane tank.
See Figure STEP 2
STEP 3
(1) Screw in the feet. See Figure I.
(2) Check each part before using the
product. Make sure the gas supply
system is turned "OFF" before
assembling. See Figure II.
(3) Locate the battery, remove the
plastic cover first. Unscrew the
rubber cap of the Electric Ignitor,
place a AAA battery into the battery
case. Make sure the positive pole
("+") towards the cap. Screw the cap
back to the battery case tightly. See
Figure III
(4) Place the lava rocks evenly in the
fire bowl on the top of the firebowl.
See Figure IV.
(5) Put the gas tank in the metal stand. Make sure the gas tank sits on the metal stand
completely. Turn the wing screw on the outer part of metal stand clockwise to secure
the gas tank tightly. See Figure V & VI
See "LP (Liquid Propane) gas supply connection" for tank connection.
INSTRUCTIONS_______________________
and 2. See the STEP 3 directly.
9