BOND MANUFACTURING HYFP30205-96 Guide D'utilisation page 13

 Please contact the Manufacturer for information regarding replacement hoses,
thermocouples, ignitors, lava rocks, etc.
TROUBLESHOOTING
PROBLEM
Appliance won't
light
Burner will not
light using a
match
Appliance emits a
lot of black smoke
when lit
Sudden drop in
gas flow
CAUSE
Igniter pin and burner are
wet
Igniter battery is incorrectly
inserted.
Igniter pin cracked or
broken
Electrode wire is loose or
disconnected
Electrode wire is shorting
between valve and igniter
pin
No gas flow
Regulator is not fully
connected to the tank
Gas flow is obstructed
Spider webs or insect nest
in the venturi (end of burner
tube)
Burner ports are clogged
Flame is obstructed at
burner ports
Regulator hose is pinched
No gas flow
Excess flow safety valve
has been activated
CORRECTIVE ACTION
Wipe dry with a cloth
Check that battery is correctly inserted.
Call customer service for replacement
part
Reconnect wire to the igniter
box located inside the table
base behind the igniter button
Call customer service for replacement
part
Check if gas cylinder is empty. If yes,
replace.
Check LP tank connection.
Check hose for bends or kinks
Clean the venturi
Insert an opened paperclip into each of
the burner ports to clean them. Ensure
the appliance is off and all parts are
cooled before attempting to clean the
burner ports
Make sure all the gas burner ports are
free of any lava rocks or debris to allow
the gas to flow freely.
Check the regulator hose for bends or
kinks
Check if gas cylinder is empty. If yes,
replace.
Turn the control knob to "OFF", Close
the LP tank valve and disconnect the
regulator from the tank. Turn the control
knob to "HIGH". Wait 1 minute. Turner
the control knob to "OFF". Reconnect
regulator to LP tank. Open tank valve
slowly. Light appliance as indicated in "To
Light" section.
13