Ecor Pro DH1100 Mode D'emploi page 5

GB
CLEANING
Disconnect from the mains before cleaning the unit or any of its components.
Cleaning the air filter
Air circulation is impeded and the efficiency of the dehumidifying and air pu-
rifying functions decreases when the filter is dirty. It is therefore good practice
to clean the filter at regular intervals. The precise intervals depend on the
room in which the appliance operates and on how frequently it is used.
• Open the filter door '1' pulling by it gently forward at the top edge
• Remove the filters '2' by sliding upwards.
• Clean the filters or wash in tap water.
• Dry the filters before inserting them
back and closing the grille.
Housing
Wipe regularly clean with a moist cloth
and mild household detergent.
Servicing
Have your dehumidifier once a year serv-
iced by a qualified engineer.
Caution
This unit should not be operated without
the air filter fitted. Operation without the air
filter may damage the heat exchanger.
DRAINAGE
Connecting the permanent outlet
The condensate drain is by default positioned at the right hand side however,
it can be repositioned to the left hand side if required. To do this, the back
panel must be removed and the tube position re-routed (this must be done by
qualified personell only)
• Connect the pipe to an outlet tube with the correct diameter.
• Push the other end of the tube into a drain, making sure that the tubing
cannot be twisted or folded.
• The entire length of the tube must have a steady fall.
• Ensure that the outlet of the drainage pipe is not under the water level in
the drain.
NOTE: In very cold weather conditions precautions should be taken to pre-
vent the drainage pipe from freezing.
8
2
AIR
FILTERS
1
DEFAULT
CONDENSATE DRAIN
CONTROLS
Your Ecor-Pro dehumidifier features a microprocessor based digital control
system for optimal performance control.
All functions are accessible via the membrane keypad shown below:
Continuous
Run Display
Fan
HI
Speed
Display
LO
Actual
Humidity
Display
Fan Speed
Select
Humidity
Adjust
Functions:
ON/OFF
The unit is switched on and off by pressing the 'ON/OFF' button. When the
unit is on, the fan runs in the set speed.
Humidity
Press the 'HUMIDITY ADJUST' button repeatedly to choose the desired level
of relative humidity in the area. The corresponding control lights will indicate
the selected percentage. The 'Continuous Run' control light indicates that
the unit is running continuously, disregarding the relative humidity level in the
area.
Fan speed
Press the 'FAN SPEED SELECT' button to select low or high speed. The cor-
responding control light will indicate this.
Humidity display
The digital display will normally show the measured relative humidity in the
area.
Compressor Operating
The 'Compressor Operating' display illuminates when the compressor is run-
ning.
9
GB
Set Point
Humidity
Display
Compressor
Operating