Battery (Insertion And Replacement) - Microson m2 BTE AT Manuel De L'utilisateur

CONFIGURATION THE CONTROL WHEEL
Your hearing aid is digital and will be configured by
your hearing care specialist according to your needs.
Follow the instructions of your hearing care specialist
in order to obtain the maximum benefit from your
hearing aid.
Depending on the configuration of your hearing aid,
you will be able to:
□
Adjust the volume using the control wheel.
Use your finger to turn the control wheel, as shown in
the figure 1.
□
Select the program with the control wheel.
Use your finger to turn the control wheel upwards,
as shown in the figure 2. The programs will change
following a cycle and you will hear a tone to indicate
which program you are setting.
Example: (two tones
Figure1
CONTROL
VOLUME MODE
PROGRAMS MODE
EN
indicate program 2)
Figure 2
VOLUME PROGRAM PROGRAM
CHANGE TONE
YES NO NO
NO YES YES
24
BATTERY (INSERTION AND REPLACEMENT)
• Remove the batteries if you do not intend to use
your hearing aids for a long time.
• Replace spent batteries immediately.
• Do not dispose of spent batteries with normal
AUTO-
TELEPHONE household waste! Take them to the hearing care
√
specialist for proper disposal without harming the
environment.
√
1. Open the battery compartment.
Remove the battery protector and
place the new battery with the
"+"symbol facing upwards. Close
the battery compartment.
If the battery is not inserted
correctly, the
hearing aid will not work.
3. To remove the battery, turn the
hearing aid upside down, open the
battery compartment and allow it to
drop into your hand.
REMEMBER THAT YOUR HEARING AID WILL BEEP THREE TIMES
YOU KNOW WHEN THE BATTERY IS SPENT.
INFORMATION
25
TO LET
EN