Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Drilling wood
•
Use Drill Mode (A)
only
•
Ensure that drill bits are suitable for wood, and are within the maximum diameter capacity of this drill
Drilling metal
•
Use Drill Mode (A)
only
•
To ensure accuracy, mark the intended hole position using a hammer and centre punch
•
Ensure that drill bits are suitable for the grade of metal being drilled, and are within the maximum
diameter capacity of the drill
•
To ensure efficient cutting, and prolong drill bit life, use a suitable lubricant/cutting fluid
GB
CAUTION: Applying excess pressure does not result in faster or more efficient drilling. If the pressure applied
to the drill has a noticeable effect on the speed of the drill then reduce the pressure. Overloading the drill will
reduce its service life.
•
As the drill bit penetrates the material being drilled, it may 'catch' or 'snag'. This can cause the machine
to suddenly 'kick', to prevent any possibility of injury always hold the drill securely, use the Auxiliary
Handle (10), and use sharp drill bits
•
Always ensure material is secure. If appropriate use a vice or clamp to hold the work, always keep two
hands on the drill
Accessories
A range of accessories for this product are available from your GMC dealer including SDS Plus drill and chisel
bits. Carbon brushes are available from www.toolsparesonline.com or your GMC dealer.
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any inspection, maintenance
or cleaning.
•
Inspect the supply cord of the tool, prior to each use, for damage or wear. This advice also applies to
extension cords used with this tool
•
if the replacement of the supply cord is necessary, this has to be done by the manufacturer or his agent in
order to avoid a safety hazard
General inspection
•
Regularly check that all the fixing screws are tight
•
Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be carried out by
an authorised GMC service centre. This advice also applies to extension cords used with this tool
Cleaning
•
Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and shorten the
machine's service life. Clean the body of your machine with a soft brush, or dry cloth. If available, use
clean, dry, compressed air to blow through the ventilation holes
•
Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol or strong
cleaning agents
•
Never use caustic agents to clean plastic parts
Lubrication
•
Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Brushes
•
Over time the carbon brushes inside the motor may become worn
•
Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
•
If you suspect that the brushes may be worn, have them replaced at an authorised service centre
Storage
After use return the drill and accessories to the supplied case and store in a damp-free environment, out of
reach of children.
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional and are
not viable for repair.
•
Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with household
waste
•
Contact your local waste disposal authority for information on the correct way to dispose of power tools
10
Publicité
Table des Matières
