Setting The First Printing Line (Tof) - Tally T2145 Manuel D'utilisation

Settings
Setting the first
You can use the TOF function for setting the position of the first printing line for each paper
printing line (TOF) source and each menu individually.
Before using the TOF function (if fanfold paper is used), you should first set the tear position
(see above).
Adjust Paperway
Menu Char Online
1 2 3 4
Setup
TOF
Head Tear Online
1 2 3 4
Setup
FormAdj= 12/72"*
Set < > Exit Online
1 2 3 4
Setup
Default TOF
0–220/72"
Readjusted TOF
16
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the TOF (3) key.
The paper is fed to the position where the bottom edge of the first printing
line is aligned with the tear edge. The factory setting for the first printing
position (TOF) is 12/72".
>
Press the < (2) or (3) key to move the first printing line to the desired position.
You can set values in the range from 0 to 220/72" for fanfold paper and for
single sheets.
Confirm the setting by pressing the Set (1) key.
Press the Setup key. The printer is reset to the initial status.
12/72"
The setting made will be retained after switching off
the printer. For more details, refer to the reference
manual on the online CD-ROM.
Quick Start-up