Troubleshooting Guide - Atlantic SOLCCSL2 Manuel D'utilisation

To loosen and tighten the brass lens ring on SOL Color Changing Spout Lights, use
the included key. Simply place the key in the slots on the brass lens ring to loosen
or tighten. Ensure that all components are installed correctly after servicing.
Inspect the silicone gaskets for defects and proper placement before
re-assembling. Ensure that the lens ring is tightly secured before submersing
the fixture.
Hardscape Wall Light Maintenance - Replacing the LED Light Strip
Make sure that the power is off before
attempting to replace the light.
Remove the screws on the existing
light, being careful not to let the light
strip fall, as this could break the plug
connecting the light to the cord.
Lower the light and squeeze the
locking clip; this will allow the plug to
be separated. Plug in the new light,
making sure the gasket has not moved
or shifted and that the notched edge
of the light strip is between the two
ridges on the cord gasket. Align the
screw holes and hand tighten the screws.
Warranty
All SOL Lighting carries a five-year limited warranty. This limited warranty is ex-
tended solely to the original purchaser commencing from the date of the original
purchase receipt and is void if any of the following apply:
• The cord has been cut or altered between the light body and the Control
Module.
• The light body / LED components have been misused or abused.
• The light body / LED components have been disassembled or modified other
than as described in this manual.
• The Control Module and/or Remote Control have not been adequately
protected from moisture.

Troubleshooting Guide

Always turn off power before inspecting the Color Changing Lights. Failure to
observe this precaution can result in a serious accident.
Before ordering repairs, carefully read through this instruction booklet. If the
problem persists, contact your dealer.
6
Figure 6.