Atlantic SOLCCSL2 Manuel D'utilisation page 4

When installing the mounting bracket, make sure to notch the stone for the
¼"cord (see Figure 4). Test fit the mounting bracket and cord, so that it does not
rock or put too much pressure on the cord. The holes in the bracket are for glue
points to hold the capstone and bracket in place. The LED light strip can be
replaced without removing the mounting bracket or capstone.
Operation
Technical Data (Control Module)
Working Temperature:
0ºF -140ºF (-20°C - 60ºC)
Output: 3 circuits (R/G/B)
Remote Control Functions
On Button
Touch and release to turn
the lights on. Touch for two
A
seconds to switch between
Color Wheel and Preset
Light Changing Modes
B Off Button
C Color Wheel
D Indicator Light
E Brightness (Up)
Preset Light Changing Modes
Continuous full spectrum
1
fade change
2
Solid Crystal White
3
Solid Red
4
Solid Green
5
Solid Blue
6
Solid Aqua
7
Solid Purple
8
Solid Yellow
9
Red-Green-Blue jump change
Preset Light Changing Modes
Mode Selection
• To switch to the Color Wheel: hold the A button for two seconds and the light
will return to the last color displayed while in the Color Wheel mode. Run your
finger around the color wheel to select a new color.
4
Input Power: AC12V
Output Power: DC12V - 80 watts max
Output Current: 2A /circuit
F Brightness (Down)
G Speed (Up)
H Speed (Down)
Preset Light Changing
I
Mode Selection (Up)
Preset Light Changing
J Mode Selection
(Down)
10
11
12
13
14
15
16
17
18
A
C
G
E
F
H
7 color jump change
Red-Green-Blue dimmer change
7 color dimmer change
7 color dimmer then
7 color jump change
Crystal White fade on/off
Flashing Red
Flashing Green
Flashing Blue
Flashing Red and Blue
B
D
I
J