Atlantic SOLCCSL2 Manuel D'utilisation page 5

• To switch to the Preset Light Changing Modes: hold the A button for two
seconds, and the light will return to the last preset mode displayed while in the
Light Changing Modes. Press the I and J button to switch between the different
preset modes.
• To switch to the Preset Light Changing Modes: hold the B button for three
seconds or until the light changes to Crystal White. Press the D button, and the
light will return to the last preset mode displayed while in the Light Changing
Modes. Press the D and E button to switch between the different preset modes.
Changing the Brightness and Speed
In all modes, you can use the E and F keys to change the brightness of the light.
In all modes, you can use the G and H keys to change the speed of the light
transitions. There are 10 levels for each.
Synchronizing the Remote to the Control Unit
If the remote control stops working properly, please install fresh batteries. If prob-
lems persist, the remote may need to be re-synced to the control module.
Follow the instructions below to re-sync the remote control:
1. Unplug the transformer.
2. Hold the E button down (The red indicator lamp on the remote will be blinking).
3. While still holding the E button down, plug in the transformer. The light will
start blinking.
• If the light blinks three times and stops, the remote and control unit are
synchronized.
• If the light blinks six or more times, it is clearing all codes. Repeat steps 1-3.
Maintenance
Spout Light Maintenance
Replacement LED Bulbs are available for SOL Color Changing Spout Lights.
Figure 5.
5