Vortice VORT HR 300 NETI Livret D'instructions page 34

ENGLISH
"No Frost Menu" page

NO FROST
UN-BALAN.
HEATER
HEAT FORC
NO FROST
UN-BALAN.
HEATER
HEAT FORC
NO FROST
UN-BALAN.
HEATER
HEAT FORC
NO FROST
UN-BALAN.
HEATER
HEAT FORC
CAUTION: The default device setting is with the "Un-Balan." function: Activated (factory default
conditions) To Activate/Deactivate this function, see: "Activate/Deactivate the Un-Balan.
Function"
CAUTION: The default device setting is with the "Heater" function: Deactivated (factory default
conditions). Therefore, in the event of electric heater (Pre-Heater) installation, the installer will
have to manually activate this function.
CAUTION: If the "Heater" function is Deactivated, the electric heater (Pre-Heater) will not
activate, even if wired.
CAUTION: If the electric heater (Pre-Heater) is not installed, the Active status of the "Heater"
function will produce a fault on "No Frost" function behaviour.
[ ▲ ]
[ ▲ ]
[ ▲ ]
[ ▲ ]
[ ▲ ]
[ ▲ ]
Factory default conditions
UN-BALAN.
[ ▲ ]
HEATER
Activate/deactivate "Un-balan." function
YES
[ ] ]
[ ]
NO
Activate/deactivate "Heater" function.
YES
[ ] ]
[ ]
NO
Activate/deactivate "Heat Forc" function.
YES
[ ] ]
[ ]
NO
YES (enabled)
NO (disabled)
▲ ▼

▲ ▼

▲ ▼
