Samsung WA45T3200A Serie Mode D'emploi page 47

Masquer les pouces Voir aussi pour WA45T3200A Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting
Checkpoints
If you encounter a problem with the washer, first check the table below and try the
suggestions.
Problem
Does not turn on.
Does not start.
Water is not supplied.
After a cycle,
detergent remains
in the automatic
dispenser.
WA3200T_DC68-03850D-00_EN.indd 47
Make sure you use rated power for the product.
Make sure the power cord is completely plugged in.
Check the fuse or reset the circuit breaker.
Make sure the door is closed.
Make sure the water taps are open.
Make sure to press or tap START/PAUSE to start the washing
machine.
Make sure Child Lock is not activated.
Before the washing machine starts to fill, it will make a series
of clicking noises to check the door lock and does a quick
drain.
Was the door opened during the spinning cycle? Close the
door, and press or tap START/PAUSE to resume.
The machine enters Standby or is in a soaking cycle. Please
wait.
Check the fuse or reset the circuit breaker
Make sure you press or tap START/PAUSE after selecting the
water supply.
Make sure the water taps are open.
Is the filter net at the water supply hose connector clogged?
Clean the filter net by brushing with a toothbrush.
Is the water supply cut off? If the water supply is cut off, close
the tap and power off.
Straighten the water supply hoses.
Open and close the door, then press or tap START/PAUSE.
If the water pressure is low, it takes longer to start washing.
If the water level is not as high as necessary or lower than
expected, use the level selector to adjust the water level.
Make sure the washing machine is running with sufficient
water pressure.
Make sure the detergent drawer is properly inserted.
Remove and clean the detergent drawer, and then try again.
Action
English 47
5/13/2020 2:40:27 PM

Publicité

Table des Matières
loading

Table des Matières