Samsung WA45T3200A Serie Mode D'emploi page 26

Installation
STEP 5 Powering your washer
STEP 6 Running a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1. Load about 6 pounds of laundry into the tub.
2. Press POWER to turn on your washer.
3. Select RINSE+SPIN by turning the Cycle Selector.
4. Press START/PAUSE to start the test cycle.
5. The washer should not rock or vibrate excessively when water is supplied or when
washing or spinning, and should drain well during the spin cycle.
NOTE
If water leaks while water is being supplied or drained, check the water connections. Refer to
the "STEP 2 Connecting the water supply hose" section on page 20 for instructions.
NOTE
If the washer rocks and vibrates excessively, level your washer again. Refer to the "STEP
4 Leveling your washer" section on page 24 for instructions.
26 English
WA3200T_DC68-03850D-00_EN.indd 26
Plug the power cord into a 3-prong,
well grounded 120 volt 60 Hz approved
electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third
prong of the power cord when plugged into
a three-prong grounded electrical outlet.
Test run
Make sure that you install your washer
correctly by running the RINSE+SPIN after
the installation is complete.
5/13/2020 2:40:23 PM