SAMES KREMLIN AIRMIX 20C50 GT Consignes D'installation Et Sécurité page 39

FLOWMAX  PUMP
Captions :
A Intensive™ or FLOWMAX ® pump (B + C)
B Air motor
C Fluid section
D Air regulator "MOTOR AIR"
E Gauge
F Air regulator "GUN AIR" (depending on version)
G Gauge (depending on version)
H Air inlet valve
I Ground
J Discharge valve
(For specific installation, please contact your SAMES KREMLIN representative).
Nota : If the pump is equipped with an accumulator filter (M), the filter is supplied with a stainless steel
screen n° 6 (filtration size : 168 microns or 85 mesh). The screen is recommended for the use of an
AIRMIX gun fitted with a nozzle model n° 6. If the fluid spraying is carried out by means of an other
nozzle, choose an other screen (refer to the filter instruction manual). Adjust the screen to the application.
Start up procedure :
1 - Ground the pump.
2 - If the pump is a intensive™ one, fill up the wetting-cup (S) with "T" lubricant (R) or with
an appropriate solvent.
3 - Unscrew the air regulators (D and F).
4 - Interconnect the air equipment with the air pressure network (clean air - Pressure < 6 bar / 87
psi). Install a water drop, model 3/4" (or model 3/8" if the pump is equipped with an air motor,
model 500/4), if it is necessary.
5 - Connect all the hoses, air hose and fluid hose (P), as well as the spray gun (Q).
Nota : Comply with the diameters of hoses recommended in the specifications of the pump.
6 - Remove the nozzle from the spray gun.
SAMES KREMLIN
G
F
T
Q
P
O
L
M
N
O
P
Q
R
S
T
- 2 -
I
M
N
Suction rod (depending on version)
Accumulator filter (depending on version)
Drain valve (depending on version)
Drain rod (depending on version)
HP Fluid hose
Spray gun
"T" lubricant (1/4 l / 0.07 US gal)
(only for intensive™ pump)
Wetting-cup
(only for intensive™ pump)
Air hose (static conductor)
N° : 578.008.120-UK-1902
B
D
E
J
H
C
L