Install Decorative Door Panels (Non-Metal Door Models); Connect The Water Dispenser - Norcold Ultraline 1210 Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Install Decorative Door Panels (non-metal door models)

The doors are made to accept decorative panels. The decorative
NOTICE
panels must be 3/16 inch or less in thickness. Install the decorative
door panels in the refrigerator doors before installing the refrigerator
in the vehicle.
1. Make two upper door panels that are 16 13/64 inches wide x 18 3/8 inches high:
- Raised panels must be centered on each door and no larger than 15 11/32
inches wide x 17 17/32 inches high.
2. Make a lower RH door panels that is 16 13/64 inches wide x 41 13/64 inches high:
- Raised panels must be centered on the lower RH door and no larger than 15
11/32 inches wide x 40 11/32 inches high.
3. Make a lower LH door panel that is 16 13/64 inches wide x 34 13/64 inches high:
- Raised panels must be centered on the lower LH door and no larger than 15
11/32 inches wide x 33 37/64 inches high.
4. Install the decorative door panels:
- Pull the panel retainer [37] off of each door [39] (See Art01794):
- Push a decorative door panel [38] into the slots of each door.
- Make sure that each panel retainer is correctly positioned and push the curved snap
[125] of the panel retainer [37] inside of the curved snap [126] of the door (See
Art01797).
- Make sure that the decorative door panel [38] of the lower LH refrigerator door is
behind the water dispenser panel.

Connect the Water Dispenser

The water dispenser is assembled to the refrigerator at the factory as optional equipment. If the refrigerator does not have a factory
installed water dispenser, one can not be added to the refrigerator at a later time.
The refrigerator installer must connect a cold water supply line to the solenoid valve at the rear of the refrigerator. The following are
necessary to connect the water dispenser.
- 1/4 in. OD copper tubing for the water supply line.
- 1/4 in. OD plastic tubing for the water supply line.
- 1/4 in. shut off valve in the water supply line. This should be easily accessible through the lower intake vent.
OR
37
38
39
Art01797
Owner's Manual 9

Publicité

Chapitres

Table des Matières
loading

Table des Matières