Replacement Parts - Norcold Ultraline 1210 Instructions D'installation Et D'utilisation

5. Put the ends of the water lines and the water solenoid valve each into a clean plastic bag.
6. Use tape to close each plastic bag around the water lines and the water solenoid valve.
To use the water dispenser after seasonal storage:
1. Remove the tape and plastic bags from the end of the water lines and the water solenoid valve.
2. Connect the dispenser water line to the water solenoid valve.
3. Connect the water supply line to the water solenoid valve.
4. Open the vehicle water supply valve to the refrigerator.
5. Push and hold the dispenser arm until the water comes out in a steady stream and does not sputter.
NOTICE
You should discard and not use the first seven glasses of water from the water dispenser.

Replacement Parts

You may purchase replacement parts through your local RV dealer or authorized Norcold Service Center.
Owner's Manual 6