Connect The Water Supply Line - Norcold Ultraline 1210 Instructions D'installation Et D'utilisation

Connect the water supply line:

Install a 1/4 in. OD water supply line [1] from the water shut off valve of the
vehicle to the solenoid water valve [2] at the rear of the refrigerator (See
Art02255):
A brass compression nut [1], a brass sleeve, a plastic sleeve [2],
NOTICE
and a brass insert [3] are supplied and attached to the rear of
the refrigerator (See Art01702).
- Put the compression nut and then the sleeve onto the water supply line [4].
- For copper tubing, use the brass sleeve.
- For plastic tubing, use the plastic sleeve [2].
- For plastic tubing with .040 in. wall thickness, also use the brass insert
[3].
- Flush the water supply line until the water is clear.
- Put the water supply line into the compression fitting of the solenoid valves.
- Tighten the compression nut by hand (hard finger tight).
- Using two wrenches, tighten the compression nut 1 ½ to 2 turns.
- Open the water shut off valve of the vehicle.
- Examine the connections for leaks.
Owner's Manual 10
3
2
1
Art02255