Roma ROLENTO B1/55 Instructions De Montage page 34

[EN]
Function note - ROLENTO
Security advice
Start-up mode
Teaching mode
Standard mode
Control unit illumination
Light barrier
Direction of engine rotation
LED STATUS
LED RADIO
Teach radio transmitters
Delete radio transmitters separately
Delete all radio transmitters
34
control unit
®
The control unit may only be put into operation by a certified electrician. There is a risk of injury from electric
shock! The local power company's regulations as well the country-specific terms are to be strictly adhered to
when connecting the unit. The control unit has to be connected to the grid with an all-pole circuit breaker (e.g.
safety plug). Prevent unauthorized use and unintentional switching-on of the door! Keep away until the door is
completely shut! The remote control is only applicable for equipment that may not cause danger for individu-
als, animals or objects in case of any dysfunction of its transmitter or receiver, or this risk is covered by other
safety device(s).
The control unit shifts to start-up mode when the cover is open. In this mode, the end limits can be adjusted.
The control unit's running direction relays remains enabled, even when the door reaches an end limit. Fine
adjustment can be carried out now by turning the end limit adjustment screws without any further command
to the control unit. Light barrier and safety edge are not working in this mode. The start-up mode may only be
activated by a qualified person!
When the cover is closed, the control unit shifts automatically to teaching mode for OPEN and CLOSE running
times. The control unit illumination blinks slowly until the running times are taught. The door must be moved
from end limit to end limit in both directions to teach the running time.
After teaching the running times, the control unit shifts to standard mode.
In standard mode and if there is no error, the control unit illumination is lit when the door is moved and for
about 3 min afterwards. The control unit illumination can be switched on and off separately via the 2nd radio
channel. In case of error, the illumination shows a defined flashing signal for the following 20 s which facili-
tates the distinction of the different error types:
1x _ 1x _ 1x _ ... Light barrier beam interrupted
   
2x _ 2x _ 2x _ ... Safety edge activated
   
3x _ 3x _ 3x _ ... Taught running time exceeded
   
4x _ 4x _ 4x _ ... Safety brake applied
   
5x _ 5x _ 5x _ ... Hard failure on circuit board
   
If connected and correctly set, the light barrier will be automatically detected by the control unit when
switched-on of 230V line currency.
The motor come correctly set. In case the engine rotates in the opposite direction, interchange the black and
blue lead on plug X3!
Is lit as soon as the control unit is energized (230V).
Is lit when a taught radio transmitter is operated.
press OPEN and CLOSE key simultaneously for 5s in standard mode
  
control unit illumination starts to flash: 1x _ 1x _ 1x _ ...
  
press the required button on the radio transmitter within 10 s
  
press simultaneously OPEN and CLOSE button on the control unit for 10s in standard mode
  
control unit illumination is lit
  
press the button on the radio transmitter which shall be deleted within 10 s
  
press simultaneously OPEN and CLOSE button on the control unit for 25s in standard mode
  
until control unit illumination fades.
  
radio transmitter is completely deleted
  