Intended Use; Parts Identification - Panasonic ES-LV6Q Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Intended use

• This WET/DRY shaver can be used for wet shaving using
shaving lather or for dry shaving. You can use this watertight
shaver in the shower and clean with water. The following symbol
means suitable for use in a bath or shower.
• Treat yourself to wet lather shaves for at least three weeks and
notice the difference. Your Panasonic WET/DRY shaver requires
a little time to get used to because your skin and beard need
about a month to adjust to any new shaving method.
• Do not bring the system outer foil into contact with hard objects.
Doing so may damage the blades as they are very thin and
deform easily.
• Do not dry the main unit with a dryer or a fan heater.
Doing so may cause malfunction or deformation of the parts.
• Do not leave the shaver exposed to direct sunlight with the foil
frame detached.
Doing so may deteriorate the waterproof rubber and degrade
waterproof function, which may cause to malfunction.
• Store the shaver in a place with low humidity after use.
Failure to do so may cause malfunction due to condensation or rust.
• Keep both the inner blades inserted. If only one of the inner
blades is inserted, the shaver may be damaged.
• If you clean the shaver with water, do not use salt water or hot
water. Do not soak the shaver in water for a long period of time.
• The following symbol indicates that a specific detachable power
supply unit is required for connecting the electrical appliance to
the supply mains. The type reference of power supply unit is
marked near the symbol.
ES-LV6Q_US.indb
9

Parts identification

a
c
d
e
A Main body
1 Protective cap
2 System outer foil
3 Foil frame
4 Smooth rollers
• They help to glide over
the skin more easily.
5 Foil frame release buttons
6 Power switch
7 Lamp display
a. Used time lamp
b. Battery capacity lamp
Back
b
b
f
g
c. Shaving sensor lamp
(
)
d. Clean lamp (
)
e. Switch lock lamp (
)
f. Foil/blade check lamp
(
)
g. Charge status lamp
(
)
8 Appliance socket
9 Outer foil section
: System outer foil release
buttons
9
2018/03/02
15:53:05

Publicité

Table des Matières
loading

Table des Matières