Adjust The Cut Height; Working Instructions; Cleaning And Maintenance - Grizzly HRM 38 Traduction De La Notice D'utilisation Originale

GB

Adjust the Cut Height

The cut height is infinitely adjustable from
14 – 43 mm:
1. Loosen the locknuts (12) on
both sides of the machine.
2. Place one foot on the castors
(9) and set the desired cut
height with both hands on the
adjusting handles (14).
Ensure that the machine is set
to the same height on both
sides.
3. Retighten the locking screws
(12).
Set the cut height no lower than to
where the blade cylinder does not
touch the ground even where it is
uneven.

Working Instructions

Regular mowing stimulates the stronger
formation of leaves in the grass as well
as allowing weeds to die off at the same
time. Thus, the lawn becomes thicker
each time it is mowed and a lawn with
even resilience is produced.
• Run the machine at walking pace, in
strips that are a straight as possible.
For seamless mowing, the strips
should always overlap by a few centi-
metres.
• On slopes, always work across the
slope.
• For the first cut of the season, choose
a high the cut height and reduce the
height to around 20 mm for the subse-
quent cuts.
20
Cleaning and
Maintenance
Have work that is not described
in these instructions carried out
by one of our authorised cus-
tomer service centres. Use only
original components.
Wear gloves when dealing with the
blades.
Before each use, check the ma-
chine for obvious defects, such
as loose, worn or damaged parts.
Check that all nuts, bolts and
screws are sitting firmly.
Check covers and safety devices
for damage and check that these
are sitting correctly. Replace if nec-
essary.
• Always keep the machine clean. For
cleaning, use a brush or cloth, but no
cleaning agents or solvents.
• After mowing, remove any plant re-
mains stuck to the wheels and the
blade area.
• Rub the blades with an oil rag or
spray them with a metal maintenance
spray.
• Due to the special cutting geometry,
the blade cylinder blades cannot be
re-sharpened. If necessary, the blade
cylinder and sub-blade must therefore
be replaced as a set. Have a special-
ist workshop carry out the installation
of the blade cylinder.