Trigger Function; Putting Out Of Operation - Binzel Abicor ABIMIG A LW Mode D'emploi

®
ABIMIG

5.9.1 Trigger function

6 Operation

7 Putting out of operation

1 Press and hold the trigger on the handle = start welding.
2 Release the trigger = stop welding.
1 Open the shielding gas cylinder.
2 Switch on the power source.
3 Switch on the coolant recirculator for ABIMIG
4 Rinse the shielding gas lines.
5 Start the welding process by pressing and holding the torch trigger.
NOTICE
• When putting the system out of operation, ensure that the procedures for
switching off each of the welding system components are observed.
• As liquid-cooled cable assemblies start to leak when they overheat, the
coolant recirculator should continue running for approx. 5 min. after
welding.
1 Wait until the shielding gas post-flow time has passed.
2 Close the shut-off-valve for the gas supply.
3 Switch off the power source.
4 Switch off the coolant recirculator.
6 Operation
® ®
W / ABIMIG W T.
EN - 19