Binzel Abicor ABIMIG A LW Mode D'emploi page 34

5 Putting into operation
5.4.3 Torch neck liner
EN - 14
®
Only for ABIMIG A T LW/ABIMIG
1
4
1 Torch neck
2 Torch neck liner
Fig. 4 Torch neck liner
1 Unscrew the torch neck (1) from the torch handle and optionally insert the
sealing plug into the torch handle.
2 Grind the torch neck liner (2) to an angle of 40° on the contact tip side
(stripped side).
3 Introduce the torch neck liner (2) with the stripped side into the torch neck
until the end stop at the contact tip (4).
®
4 ABIMIG A T LW:
Slide in the torch neck liner and shorten it at the end free of the retaining
nipple until it flexibly protrudes 2 mm from the retaining nipple.
®
ABIMIG W T:
Cut off the torch neck liner (2) with an excess length of 12 mm from the
current contact area (3) free of burrs.
5 Deburr the cutting edges.
6 Where applicable, remove the sealing plug and screw the torch neck (1)
into the torch seat on the torch handle.
®
W T change neck torches.
3 Current contact area
ABIMIG
2
12
3
2
2
3
4 Contact tip
®