Binzel Abicor ABIMIG A LW Mode D'emploi page 32

5 Putting into operation
EN - 12
3 Unscrew the insulating piece (2) from the torch neck seat using a flat head
screwdriver (width approx. 10 mm).
4 Optionally seal the torch neck with the sealing plug (10).
5 Unscrew the nut (6) from the central connector (7).
6 Push out the liner (9) from the central connector (7) until reaching the end
stop of the liner's nipple in the torch.
7 Screw on the nut (6) hand tight.
8 Cut off the liner (9) at the front of the torch handle (3) or sealing plug (10)
so that it is flush.
9 Unscrew the nut (6).
10Pull the liner (9) back out.
11 Cut the front of the liner (9) back 40 mm (or 53 mm if using the sealing
plug (10)) and grind it to an angle of 40°. The liner's insulation must not
be further removed in either case.
12 Deburr the cutting edges.
13 Screw the insulating piece (2) hand tight into the torch neck seat (small
edge first).
14 Push in the liner (9).
The remaining excess length of the nipple (approx. 14 mm) of the liner (9) is
used to preload the liner.
15 Screw on the nut (6).
®
ABIMIG