Hilti SD 4500-A22 Mode D'emploi page 19

7.2 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of
transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a
window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by
children or unauthorized persons.
▶ Check the tool and batteries for damage before use after long periods of
storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are
unable to remedy the problem by yourself, please contact Hilti Service.
Trouble or fault
The screwdriver
doesn't work.
The screwdriver
doesn't work and
one LED blinks.
*2153708*
Printed: 15.07.2019 | Doc-Nr: PUB / 5295856 / 000 / 02
Possible cause
Low battery.
The battery is not in the
working position.
Low battery.
The battery is too hot or
too cold.
2153708
Action to be taken
▶ Charge the battery.
→ page 9
▶ Insert the battery.
→ page 10
▶ Insert a charged
battery.
▶ Charge the battery.
→ page 9
▶ Bring the battery to
the recommended op-
erating temperature.
English 13