Using The Appliance; Installation - VALBERG DC 8 B W566C Consignes D'utilisation

B

Using the appliance

Installation

For your convenience, it is possible to connect your condensing dryer to the water drain.
Please note! As the drain hose is not included in the delivery, we recommend that you buy one
separately. Your dryer is equipped with a hose, but it is too short.
• Use pliers to extract the drain hose.
• Insert the drain hose into the hose connector.
• Install the hose holder on the sink or any other washbasin.
Transportation
Use caution when moving the appliance. Never grasp the appliance by its protruding parts. Do
not use the door of the appliance as a handle during delivery.
Installation location
1. For convenience, install the dryer near your washing machine.
2. The dryer should be installed in a clean, dust-free location. Air must be able to circulate freely
around the appliance. Never obstruct the air intake located at the front, or the air intake grilles
located at the rear of the machine.
3. In order to minimise vibration and noise while the dryer is operating, the appliance should be
placed on a firm level surface.
4. Never remove the feet. Be careful not to clutter the surrounding floor by fitting long-pile rugs,
wooden planks or the like. This is likely to cause a build-up of heat which may interfere with the
correct operation of the appliance.
200cm
6 EN
B
Using the appliance
Levelling
Once the appliance is in the permanent position, in which it will be operating, check that it is
perfectly level using a spirit level. If not, adjust the appliance's feet using a tool.
Power supply connection
1. Make sure that the voltage of the power supply is identical to the specified voltage of the dryer.
2. Do not connect your dryer using a multi-socket, universal plug or universal socket.
7 EN