Datamars Unigizer 15000i Mode D'emploi page 10

Testing the battery voltage
The energizer's Battery Test setting can be used to monitor the battery voltage.
When the selector switch is set to Battery Test , the Indicator lights show the input supply voltage. This can be useful in order to
monitor the battery charge level.
Note:
When the selector switch is set to Battery Test , the energizer pulses at slow speed (2.5 seconds between pulses) and the
fence is live.
Lights
or
Notes:
- In extreme temperatures, these guidelines may not apply.
- The battery test results will display for 30 seconds after the selector switch is set to Battery Test .
When the selector switch is set to Battery Test , the LCD display also displays the input supply
When the voltage is outside the normal range (below 11.8 V or above 17 V), the battery symbol
flashes.
During normal operation, when the selector switch is set to
the LCD display flashes. Recharge the battery immediately.
10
Input supply
voltage Battery-only installation
Above 17.0 V Abnormal conditions, check battery and connections.
12.6 V-17.0 V Full battery charge voltage (80-100%):
• No action required.
12.3-12.6 V Medium battery charge voltage (50-80%):
• No action required.
12.0-12.3 V
11.7-12.0 V Low battery charge voltage (20-50%):
• Monitor battery voltage.
• Recharge the battery to avoid long-term damage to the battery.
11.2-11.7 V Bad battery charge voltage (10-20%):
• Recharge the battery immediately.
• Energizer will automatically revert to Slow Speed and Low Output Power in order to
preserve the remaining power and energy in the battery.
Below 11.2 V Very bad battery charge voltage:
• Recharge the battery immediately
• The energizer will not function in order to preserve the battery.
, , or , if the battery voltage is bad, the battery symbol on
voltage.