Hobby Services Accu-Cycle Pro Serie Manuel D'instructions page 4

Problem: Low mAh/time readings after discharge cycle.
Cause: 1) Batteries not fully charged prior to discharge. 2) Old or unused batteries. 3) Defective battery. 4) Possible logic
problem with Accu-Cycle.
Solution: 1) Fully recharge batteries. 2) Cycle again to see if capacity improves. 3) Replace the battery. 4) Contact Hobby
Services for further details.
Problem: LEDs and controls do not function properly.
Cause: Battery possibly connected backwards.
Solution: Connect battery leads properly, or contact Hobby Services for further details.
Receiver and Transmitter Charge Jack Polarities
Negative
Futaba/KO Old Airtronics/Sanwa
Airtronics "Z"
Note: The signal wire in the charge lead is not used when charging receiver packs.
Warning: Be very cautious of reverse polarity when using JR charge leads.
Accu-Cycle Specifications
Input Voltage: 220V AC
Fast Charge Termination: 15 Hour Timer
Output Connections: Banana Jacks
Transmitter Charge Rates: 50, 125 milliamps (mA)
Receiver Charge Rates: 25, 50, 125 milliamps (mA)
Discharge Rates: 250, 500 milliamps (mA)
LCD Readout: Milliamp-hours and elapsed time in minutes
For warranty information outside of the United States and Canada, please consult your local dealer.
For service on your Hobbico product, either in or out of warranty, send it post paid and insured to:
Made in China
Receiver Polarities
Positive
Negative
Positive
Signal
Signal
JR/Hitec
HOBBY SERVICES
1610 Interstate Drive
Champaign, IL 61822
Negative
Positive
Signal
(217) 398-0007
4
Transmitter Charge
Jack Polarities
Futaba, Hitec, KO
Airtronics/Sanwa
+ -
-
© Copyright 1999 3045065
JR
+