Cleaning; Storage; Troubleshooting - TECMIX TBR 2000 Mode D'emploi Original

5.3 Cleaning

• The concrete vibrator and the drive units must be cleaned of concrete residues at the end of
the work.
Clean the unit and all its components with water after each use.
check the connection cable for damage.
• The vibrating body must not be immersed in liquids containing acids or alkalis.
• Also, do not use fuels or solvents. Danger of explosion!
• Do not use high-pressure cleaners. Penetrating water can damage the unit. At
Electrical appliances pose a serious risk of injury from electric shock.
• Hose shafts and drive couplings or connections must be greased regularly.

5.4 Storage

• Place or lay down the unit securely so that it does not tip over, fall down or
can slip away.
• After operation, store the cooled unit in a locked, clean place,
frost-protected and dry place that is inaccessible to children.

6. Troubleshooting

Error
The unit will not start.
Reduced power output.
Unit is not running.
Pendulum shaft does not start.
Vibrating bottle hums or runs
rough.
34
Cause
Operating errors
Electrical connection
Plug connections
loose/defective
Operating errors
Bearing damage
Solution
Carry out the starting procedure as
prescribed.
Switch off immediately!
Check plug and switch.
All phases in the plug live?
Check connection. Supply line
Check for continuity.
Check on/off switch.
Vibrator or drive damage, have repaired by
a qualified specialist if necessary.
Knock the vibratory bottle head part hard;
this activates the pendulum.
From a qualified professional
have it repaired.