Switching Off The Unit - TECMIX TBR 2000 Mode D'emploi Original

Hint:
• Compact particularly intensively in the area of the formwork corners, because there the
reinforcement density is greatest
• Avoid contact of the vibrating body with the reinforcement
If the vibrating body touches the reinforcement, the following damage can occur:
- The bond between the concrete and the reinforcement can be lost.
- The unit may be damaged.
• The result of the compaction depends on the following points:
- Dwell time of the vibrating body in the concrete.
- Diameter of the vibrating body.
- Consistency of the concrete.
- Reinforcement density.
• For example, if you use a small diameter vibratory body, you need to compact longer to achieve
the same effect as with a large diameter.
• Characteristics of when the concrete is sufficiently compacted:
- The concrete no longer settles.
- No or hardly any air bubbles rise.
- The sound of the vibrating body no longer changes.
3.4 Switch off the unit
• Slowly pull the unit out of the fresh concrete, keep the vibrating body in the air.
• Switch off the unit with the on/off switch.
• Wait until the unit has come to a complete stop.
• Put the unit down slowly.
• Do not kink the protective hose and connection cable.
• Pull the plug out of the socket.
32