Remedy Of Faults; Maintenance And Cleaning - Oase IceFree 4 Seasons Notice D'emploi

- EN -
Fitting the pump
N O T E
In warm temperatures, the pump must sit higher in the water than in cold temperatures. More particles of dirt
are generated in warm temperatures, particularly at the bottom of the pond. These may damage the pump or
impact its flow rate.
 Only use one hose.
 Shorten the hose if necessary.
 Use a filter bag.
 E
 See winter mode. (→ Fitting the pump)
 Enclose the pump in the filter bag and close the filter bag tightly.
– This protects the pump from fine dirt particles.
Commissioning/start-up
N O T E
Prevent the pump from running dry. Otherwise the pump will be destroyed.
 Only operate the pump when it is immersed.
This is how to connect the power supply:
To turn on: Connect the unit to the electrical outlet. The unit switches on immediately.
To turn off: Disconnect the unit from the electrical outlet.

Remedy of faults

Malfunction
The unit is not pumping water

Maintenance and cleaning

For cleaning and maintenance, take the unit out of the water and dismantle it. If necessary, the impeller unit can also
be replaced this way.
W A R N I N G
Electrical current may cause death or severe injuries.
 Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Prior to reaching into the water, disconnect units and installations from the mains.
 Disconnect the power plug before carrying out any work on the unit.
 Secure the unit to prevent unintentional switching on.
8
Cause
No power supply
Hose is not hanging straight, is twisted or dirty
Pump housing, filter bag and/or nozzle is dirty
Volcano nozzle is screwed all the way into the
nozzle pipe
Remedy
Check the power supply
Check/clean hose
Clean
Unscrew the nozzle slightly